ESC-Group-Logo-R-PNG.png
Misi.png
ESC-CRU SERIES
U PROFILE SHEET PILES

The ESC-CRU series is a cold rolled sheet pile profile. U-shaped steel sheet piles have long been familiar to designers and constructors because of the long-standing traditions and technologies, and are widely used for permanent structures, temporarily installed soil-retaining construction and temporary cofferdams. ESC-CRU profiles provide an economic alternative to Hot Rolled U Sheet Piles as they are of similar size and possess similar structural properties, with a  section modulus ranging from 9.3in3/ft all the way up to 86.5in3/ft. With over 50 choices in profile, the CRU series sheet piles allow greater fine tuning in the design for the most economical solution.

TECHNICAL SPECIFICATIONS

* Excludes internal section of interlock.

Section Modulus Range

​20.4-93in3/ft

Width Range (single)

​22.8-31.5in

Thickness Range

​0.19-0.62in

Production Standards

​BS EN 10249 Part 1 & 2

​Steel Grades​
  • Q235B, Q345B, Q345C, Q390B, Q420B

  • S235JR, S275JR, S355JR, S355JO

  • ASTM A572 Gr42, Gr50, Gr60

  • Others available on request

Length

114.8ft maximum

Standard Stock Lengths of 19.6ft, 29.5ft, 39ft, 49ft

Delivery Options
  • Single or Pairs

  • Pairs either loose, welded or crimped

  • Lifting Hole

  • By container (38.7ft or less) or Break Bulk

  • Corrosion Protection Coatings

Corner Piles

ESC is able to offer 3 options for Corner Pile configurations in the ESC-CRU Series. Option 1 is frequently used when the installation contractor prefers to create their own corner piles on site depending on the as-driven layout. However this produces wastage on the offcut pile. Option 2 allows welding at the mill or on site and provides the installation contractor with more flexibility on  corner pile location. Option 3 provides an option with no welding required and provides increased accuracy at corners that are deviated from the typical 90˚ corner.

Other Configurations

ESC-CRU Series Sheet Piles can be combined to create special arrangements. These combined sections presented can greatly amplify the bending strength of a single section by over 5 times. Box Piles with intermediate standard U Piles can be designed. The welded box section can also be incorporated along a certain section of the length where the bending moments are the highest. Please contact our engineering department at engineering@escsteel.com if you would like to receive more information about the presented combined pile systems.

1/3
Catalog
Datasheets
Drawings
Daha Fazla Göster

Corner pile options.

1/5

Other Configurations.