COLD FORMED SHEET PILES
The ESC CFW series was developed to enable a wide profile sheet pile to be produced economically without any requirement for interlock clutch welding. ESC-CFW sheet piles have excellent driveability due to the interlock design. A large range of sizes and strengths can be designed. The manufacturing process gives full flexibility in the profile design allowing features such as corner piles, tapered piles.
Section Modulus Range
Width Range (single)
BS EN 10249 Part 1 & 2
Q235B, Q345B, Q345C, Q390B, Q420B
S235, S275JR, S355JR, S355JO
ASTM A572 Gr42, Gr50, Gr60
Others available on request
Longer lengths can be spliced (>98.4ft possible)
Any project specific length can be produced
By container (38.7ft or less) or Break Bulk
Corrosion Protection Coatings
Due to the flexibility of the forming process, the ESC-C-CFW Series Sheet Piles can be formed to almost any corner configuration, without requiring any wastage or welding. Note that the interlocks should be orientated toward the retained side as shown in the following figures.